Stratasys F770 - Bellows, Right;Left

Customer Replaceable Units Bellows, Right/Left
Page 198
© Copyright 2021 Stratasys. All rights reserved.
Bellows, Right/Left
Required Tools
• 3 mm hex wrench
Removing the Bellows
1. Power OFF the printer.
2. Open the appropriate top side access door.See “Opening Top Access Doors Left/Right”
(page 183).
3. Open the oven door.
4. From inside the oven enclosure, use a 3 mm hex wrench to remove the screws (5)
securing the bellows to the Y bridge.
5.
When performing maintenance procedures inside the gantry area, power must be removed from
the printer, or the top right access door must remain open to ensure that the interlock is
disengaged.
The following procedure depicts the right side bellows only. This procedure is identical
for the left side bellows.
Always perform lockout-tagout of the AC power cord in accordance with
customer site procedures.
Warning: Hot Surfaces
Allow the interior of the printer’s oven enclosure to cool down before continuing
this procedure.
Move the Y-bridge as necessary to access bellows mounting screws.