Working with the Build Page Build Status Display
Page 49
© Copyright 2021 Stratasys. All rights reserved.
Build Status Display
The Build Status Display section of the Build page is composed of a two-part graphic. The
center portion provides information on a selected and/or building job while the outer progress
ring corresponds with the build information displayed; the information displayed will vary
depending on the state of the printer.
Figure 10: Build Status Display Overview
Idle
When the printer is idle, "IDLE" will be displayed within the center of the Build Status Display.
This indicates that the printer is in a state where it is ready to start a build. No progress is
indicated within the outer build progress ring and the time remaining is displayed as zero.
Figure 11: Build Status Display - Idle
Build Status
Information
Build
Progress
Ring
To Next Page
Loading...
