Stratasys F770 - Tips, Slice Height, and Build Sheets

Modeling Materials Tips, Slice Height, and Build Sheets
Page 39
© Copyright 2021 Stratasys. All rights reserved.
Tips, Slice Height, and Build Sheets
The F770 printer utilizes a T14 tip for all model and support materials. Tips are a component of
the associated head assembly and cannot be changed individually. Instead, the entire head
assembly is replaced as a single unit.
Table 3 lists the types of model material available for use with the printer, their corresponding
support material, and their corresponding build sheets.
Table 4 lists available slice heights.
Table 3: Available Material Types
Model Material Support Material Build Sheet
ASA SR30 Standard
ABS SR30 Standard
Table 4: Slice Height
Model Tip Slice Height (in) Slice Height (mm) Material
T14
0.007 0.178 ABS, ASA
0.010 0.254 ABS, ASA
0.013 0.330 ABS, ASA