Stratasys F770 - Errors Preventing a Build from Starting

Warnings and Errors Errors Preventing a Build from Starting
Page 235
© Copyright 2021 Stratasys. All rights reserved.
• Correct condition - you are able to continue building using this head but it is recommended
that you change the head prior to starting a new build (see “Head Replacement”
(page 121)).
Replace support head
• The support head has reached 1500 build hours (odometer limit). Build hours are available
within the head’s Head Details page (see “Viewing Head Details” (page 64)).
• Correct condition - you are able to continue building using this head but it is recommended
that you change the head prior to starting a new build (see “Head Replacement”
(page 121)).
Errors Preventing a Build from Starting
Printer busy
• Indicates that the printer is in the process of completing another task and a build cannot be
started until the task is complete.
• Correct condition - wait a couple of minutes and then attempt to restart the build.
Close the door
• Indicates that the oven door is open.
• Correct condition - close the oven door.
Close the cover
• Indicates that the top cover is open.
• Correct condition - close the top cover.
Remove the part
• Indicates that the completed part from the previously built job is still in the printer’s oven
chamber.
• Correct condition - open the oven door and remove the completed part. See “Removing a
Part from the Printer” (page 133) for instructions.
Select a job
• Indicates that a job has not been selected for building.
• Correct condition - select the job you’d like to build from the Job Queue. See “Selecting a
Job to Build” (page 126) for instructions.
No vacuum detected
• Indicates that the build sheet is not tightly secured to the platen.
• Collect condition - Ensure build sheet is installed smooth side down, that no debris is under
the build sheet (especially under outer row of gridlines), and that the build sheet is
completely covering all platen grid lines. If this doesn't work, try a new build sheet.
Insert a model head
• Indicates that a model head has not been installed into the printer.