Stratasys F770 - Units

Working with the Tools Page Settings
Page 83
© Copyright 2021 Stratasys. All rights reserved.
To configure this setting, press anywhere within the row; the First Layer Material page will be
displayed. Use the radio buttons within this page to select between Model and the Default
material, which could be either model or support material. If ABS or ASA material and .005”
slice height are selected, model material is automatically used for the first layer of material.
Figure 44: Configure First Layer Material
Units
The Units row displays the type of units the printer is configured for, English (inches) or Metric.
Figure 45: Units
To configure this setting, press anywhere within the row; the Units page will be displayed. Use
the radio buttons within this page to select between English and Metric units; English is
selected by default.
Figure 46: Configure Units