Printer Status MTConnect System Activation
Page 143
© Copyright 2021 Stratasys. All rights reserved.
MTConnect System Activation
Activating the MTConnect system enables the MTConnect data exchange protocol between
the printer and an MTConnect client for the purpose of tracking printer defined metrics.
MTConnect is available for all F123 Series systems and requires firmware Version 2.2.5940 or
later.
MTConnect must be enabled on the printer. To do this from the Home Screen:
1. Select the Tools screen.
Figure 38: Home Screen
Firmware version 2.2.5940 (or later) is recommended for all systems.
To Next Page
Loading...
