Stratasys F770 - Load;Unload Errors

Warnings and Errors Load/Unload Errors
Page 237
© Copyright 2021 Stratasys. All rights reserved.
• Correct condition - wait at least 60 seconds after the error is first displayed. If the error
persists, open the top cover and unclip the head cable from the support head. Wait a few
seconds and then reconnect the head cable to the support head and close the top cover
(see “Head Replacement” (page 121) for details). If the error persists there is likely a
problem with either the head or the head cable; please contact Stratasys Customer
Support or your regional Stratasys office for further assistance (see “Getting Help”
(page 233) for contact information).
Load model material
• Indicates that model material has not been loaded into the printer.
• Correct condition - load model material. See “Loading Material” (page 107) for instructions.
Load support material
• Indicates that support material has not been loaded into the printer.
• Correct condition - load support material. See “Loading Material” (page 107) for
instructions.
Replace invalid model spool
• Indicates that the material coil box is invalid. Invalid materials are materials not licensed or
not compatible with the associated head type.
• Correct condition - disconnect the invalid material coil box and replace it with a valid
material coil box. See “Handling/Storing Materials” (page 121) and “Connecting Material
Coil Box To Printer” (page 108) for instructions.
Replace invalid support spool
• Indicates that the material coil box is invalid. Invalid materials are materials not licensed or
not compatible with the associated head type.
• Correct condition - disconnect the invalid material coil box and replace it with a valid
material coil box. See “Handling/Storing Materials” (page 121) and “Connecting Material
Coil Box To Printer” (page 108) for instructions.
Replace empty model spool
• Indicates that the material coil box has run out of material.
• Correct condition - disconnect the empty material coil box and replace with a new material
coil box. See “Handling/Storing Materials” (page 121) and “Connecting Material Coil Box To
Printer” (page 108) for instructions.
Replace empty support spool
• Indicates that the material coil box has run out of material.
• Correct condition - remove the empty material coil box and replace with a new material coil
box. See “Handling/Storing Materials” (page 121) and “Connecting Material Coil Box To
Printer” (page 108) for instructions.
Load/Unload Errors
Timed out
• Indicates that filament was not detected at the head within 5 minutes of a load’s initiation.