Oven Components Purged Material
Page 33
© Copyright 2021 Stratasys. All rights reserved.
Purged Material
Purged material collects on the right side of the oven. Purged material debris falls from the tip
wipe assemblies to the bottom of the oven chamber. Accumulated material debris should
always be cleaned on a weekly basis, or as needed if excessive accumulation occurs, see
“Cleaning the Oven Chamber” (page 178) for instructions.
Figure 9: Oven Chamber Cleaning Location
Material Coil Box
The F770 printer uses a material coil box (Figure 10) to supply both model and support
material to the printer. The material coil box is external to the F770 printer and must be
manually loaded to one of the printer filament ports (Figure 10). Each material coil box has a
filament key which interfaces with the system at the filament port. Within each filament port is a
Purged
material
debris will
accumulate
here
To Next Page
Loading...
