Safety Instructions General Safety Practices
Page 11
© Copyright 2021 Stratasys. All rights reserved.
General Safety Practices
Abide by these general safety practices when working with this printer.
Environmental Requirements
• The F770 printer is for indoor use only.
• Air quality conditions with excessive solid particulates (conductive or non-conductive) may
result in system damage.
• Air quality conditions in which airborne oils are allowed to accumulate on or within the
printer can damage the plastic components.
• System operating temperature shall be in the range of 59°F to 86°F (15°C to 30°C), with
relative humidity range of 30% to 70% non-condensing.
• System storage temperature shall be in the range of 32°F to 95°F (0°C to 35°C), with
relative humidity range of 20% to 90% non-condensing.
• Altitude shall not exceed 6561.68 feet (2000 m).
• Material storage shall be in the range of 55°F to 86°F (13°C to 30°C), with relative humidity
less than 70%.Noise emission (acoustic):
• <65dBA when idle
• <65dBA when building
Warning: High Voltage.
High voltage is present in the printer.
Warning: Falling Hazard.
Only use an OSHA or CE approved step stool when accessing the area under the
top cover of the printer.
Warning: Hot Surfaces.
Always wear safety gloves and long sleeves when working inside the oven.
Components are hot.
To Next Page
Loading...
