Safety instructions 15
5.7 Special dangers
The following section describes the residual risks that result from the hazard analysis.
The safety and warning instructions must be observed in order to reduce risks to health as
well as dangerous situations.
DANGER
Risk of fire due to highly flammable liquids or gases.
When working with inks, paints and thinners, there is a risk of fire due to
flammable or explosive liquid or gaseous substances.
• No fire or naked flames permitted in close proximity to inks and sol-
vents.
• No smoking or lighters/matches.
• Keep all sources of ignition which form sparks away from welding/grin-
ding work or electrostatic discharges.
DANGER
Danger to life caused by electric current.
Touching live parts represents an immediate danger to life. Damage to
components or the insulation of cables and electric lines may pose a dan-
ger to life.
• The current supply must be switched off immediately and the damage
must be repaired if the insulation is damaged.
• Ensure that live parts are kept dry.
• Work on electrical equipment may only be performed by specialist
electricians according to the valid rules and regulations.
• Ensure that the machine is disconnected from the current supply prior
to commencing work on electrical components of the machine.
• Ensure that the current supply is switched off and that the machine is
not live prior to servicing, cleaning and repair work.
• Ensure that the machine is secured against being switched back on.
• Do not bridge fuses or take them out of operation.
• When fuses are replaced, ensure that they are only replaced by fuses
of the same type.
To Next Page
Loading...