Commissioning 37
11 Commissioning
11.1 Connecting the voltage supply
The machine may only be connected to an electricity network that complies with the speci-
fications in the technical data and on the type plate.
The mains is connected via the mains supply module
located on the rear of the machine.
• Switch off the mains switch B (position 0).
• Plug the mains cable into the port C.
• Connect the mains cable to a socket.
WARNING
Improper handling of machines and devices can lead to serious
injury.
A faulty electrical or pneumatic connection on the machine can result in
the machine behaving uncontrollably and may lead to unexpected move-
ments. This poses a risk of injury.
• The installation and initial commissioning of the machine may only be
performed by employees of the manufacturer or trained specialist per-
sonnel.
• The manufacturer must also be consulted if the machine is relocated at
a later date.
• Unauthorized installations and relocations are not permitted.
• Damaged cables and connectors may not be used.
• The machine may only be connected to a socket with a protective
earth conductor that complies with the local regulations.
C
B
To Next Page
Loading...