Universal Robots UR16e

5.1. Setting a Software Safety Password
Description You must set a password to Unlock all safety settings that make up your
Safety Configuration. If no safety password is applied, you are prompted to
set it up.
To set a Software
Safety password
You can tap the Lock tab to lock all Safety settings again or simply
navigate to a screen outside of the Safety menu.
1. In your PolyScope header right corner, press the Hamburger menu
and select Settings.
2. On the left of the screen, in the blue menu, press Password and
select Safety.
3. In New password, type a password.
4. Now, in Confirm new password, type the same password and press
Apply.
5. In the bottom left of the blue menu, press Exit to return to previous
screen.
UR16e 132 User Manual
Copyright © 2009–2024 by UniversalRobotsA/S. All rights reserved.