Universal Robots UR16e

2.5. Transportation
Only transport the robot in its original packaging. Save the packaging material in a dry place if you
want to move the robot later.
When moving the robot from its packaging to the installation space, hold both tubes of the robot arm
at the same time. Hold the robot in place until all mounting bolts are securely tightened at the base of
the robot.
Lift the Control Box by its handle.
WARNING
Incorrect lifting techniques, or using improper lifting equipment, can lead to injury.
•
Avoid overloading your back or other body parts when lifting the equipment.
•
Use proper lifting equipment.
•
All regional and national lifting guidelines shall be followed.
•
Make sure to mount the robot according to the instructions in Mechanical
Interface.
NOTICE
If the robot is attached to 3rd-party application / installation during transport, please
refer to the following:
•
Transporting the robot without its original packaging will void all warranties
from UniversalRobotsA/S.
•
If the robot is transported attached to a 3rd-party application / installation,
follow the recommendations for transporting the robot without the original
transport packaging.
Universal Robots cannot be held responsible for any damage caused by transportation of the
equipment.
You can see the recommendations for transportation without packaging at:
myur.universal-robots.com/manuals
2.5.1. Transport Without Packaging
UniversalRobots always recommends transporting the robot in its original packaging.
These recommendations are written to reduce unwanted vibrations in joints and brake systems and
reduce joint rotation.
If the robot is transported without its original packaging, then please refer to the following guidelines:
UR16e 56 User Manual
2.Part I Hardware Installation Manual
Copyright © 2009–2024 by UniversalRobotsA/S. All rights reserved.