Time
Description You can access and/or adjust the current time and date displayed on the
PolyScope.
Time 1. In the Header, tap the Hamburger menu icon and select Settings.
2. Under Preferences, select Time.
3. Verify and/or adjust Time and/or Date as desired.
4. Tap Apply and Restart to apply your changes.
Date and Time are displayed in the Log tab (see Date Logon page335)
under Date Log.
13.2.2. Password
Description Password contain the management of passwords and administrator's
password.
Password Settings
Setting a Password You must set a password to Unlock all safety settings that make up your
Safety Configuration. If no safety password is applied, you are prompted to
set it up.
To set a Password 1. In your PolyScope header right corner, press the Hamburger menu
and select Settings.
2. On the left of the screen, in the blue menu, press Password and
select Safety.
3. In New password, type a password.
4. Now, in Confirm new password, type the same password and press
Apply.
5. In the bottom left of the blue menu, press Exit to return to previous
screen.
You can press the Lock tab to lock all Safety settings again or simply
navigate to a screen outside of the Safety menu.
User Manual 347 UR16e
Copyright © 2009–2024 by UniversalRobotsA/S. All rights reserved.
To Next Page
Loading...
