To set the Mode
Password
1. In the Header, tap the Hamburger menu icon and select Settings.
2. Under Password, tap Mode.
3. Under New password, create a new password.
Creating a strong, secret password obtains the best security for your
system.
4. Under Confirm new password, repeat your new password.
5. Tap Apply to confirm your password change.
13.2.3. System
Description The system settings control backup of the system, URcaps and networks
settings among other.
System Backup
Description
NOTICE
Use one of the USB ports inside the Control Box (CB) when
doing a Backup and Restore operation. Using a CB USB
port is more stable and running a Backup requires less
time.
NOTICE
If you restore a system with a new SD card, you must match
the Serial Number in the new SD card image when you start
up Polyscope. Failure to match the Serial Number can
result in an incomplete restore process. A restore error
appears for not finding the matching serial number
Backup and Restore Save a full copy of your system to a USB drive and use it to restore your
system back to a previous state. This may be necessary after disk
corruption or accidental deletion.
UR16e 350 User Manual
Copyright © 2009–2024 by UniversalRobotsA/S. All rights reserved.
To Next Page
Loading...
