Vacon 100 - Page 126

Table 38: Frequency reference parameters
Index Parameter Min Max Unit Default ID Description
P3.3.1.10
Fieldbus Control
Reference Selection
0 19 3 * 122
Selection of the
reference source when
the control place is
Fieldbus.
0 = Preset frequency 0
1 = Keypad
2 = Fieldbus
3 = AI1
4 = AI2
5 = AI1+AI2
6 = PID reference
7 = Motor
potentiometer
8 = Joystick
9 = Jogging reference
10 = Block Out.1
11 = Block Out.2
12 = Block Out.3
13 = Block Out.4
14 = Block Out.5
15 = Block Out.6
16 = Block Out.7
17 = Block Out.8
18 = Block Out.9
19 = Block Out.10
* = The selection of the application with parameter P1.2 Application gives the default value.
See the default values in Chapter 11 Appendix 1.
VACON · 126 PARAMETERS MENU
5
TEL. +358 (0)201 2121 · FAX +358 (0)201 212 205