Vacon 100 - Page 175

Table 83: Setpoint settings
Index Parameter Min Max Unit Default ID Description
P3.13.2.6
Setpoint source 1
selection
0 32 3 * 332
0 = Not used
1 = Keypad setpoint 1
2 = Keypad setpoint 2
3 = AI1
4 = AI2
5 = AI3
6 = AI4
7 = AI5
8 = AI6
9 = ProcessDataIn1
10 = ProcessDataIn2
11 = ProcessDataIn3
12 = ProcessDataIn4
13 = ProcessDataIn5
14 = ProcessDataIn6
15 = ProcessDataIn7
16 = ProcessDataIn8
17 = Temperature input
1
18 = Temperature input
2
19 = Temperature input
3
20 = Temperature input
4
21 = Temperature input
5
22 = Temperature input
6
23 = Block Out.1
24 = Block Out.2
25 = Block Out.3
26 = Block Out.4
27 = Block Out.5
28 = Block Out.6
29 = Block Out.7
30 = Block Out.8
31 = Block Out.9
32 = Block Out.10
The AIs and the
ProcessDataIn are
handled as percentages
(0.00-100.00%) and
scaled according to the
setpoint minimum and
maximum.
NOTE!
The ProcessDataIn
signals use 2 decimals.
If you set temperature
inputs, you must set the
setpoint minimum and
maximum scaling
parameters between -50
and 200 °C.
PARAMETERS MENU VACON · 175
24-HOUR SUPPORT +358 (0)201 212 575 · EMAIL: VACON@VACON.COM
5