Cab
ROPS (Roll Over Protective Structure)
The cab is designed to ensure minimum crash
protection space according to ROPS standard for
excavator (ISO12117-2:2008).
The installation of any additional equipments
resulting in exceeding maximum tested machine
weight on a ROPS identification plate, may void
ROPS certification.
Do not jump out of cab if the machine should roll
over. Keep stay in seat wearing seat belt.
If any part of the cab's protective structure is
affected by plastic deformation or failures, the cab
shall be replaced immediately.
NOTE!
Never carry out any unauthorized alterations to the
cab, for example lowering the roof height, drilling,
welding on brackets for fire extinguisher, radio
aerial or other equipment, without first having
discussed the alteration with personnel at the Volvo
Engineering Department. This department will
decide whether the alteration may cause the
approval to become void.
It is important that all parties concerned are aware
of these regulations.
106
Other controls
Cab
To Next Page
Loading...
