Hydraulic oil level, checking
Check the oil level every 50 hours.
1 Park the machine in service position B, see page
270
.
2 Move the control lockout lever down to lock the
system securely and stop the engine.
3 Open the side door on the right side of the
machine and check the oil level in the sight
gauge. If the level is in the center of the gauge,
the level is correct.
4 If the level is low,
- Press breather (A) to release the internal
pressure at the tank.
- Remove filling plug (B) and top up with
hydraulic oil.
NOTE!
To top up the oil efficiently press air breather again.
- Check the level.
- If the level is normal, install the filling plug.
NOTICE
Use the same hydraulic oil that is already in the
system. The hydraulic system may be damaged if
different brands of hydraulic oil are mixed.
5 If the level is high,
- Place a suitable sized container under the
hydraulic tank.
- Remove the protecting cap (F) and attach drain
hose (G).
- Drain the oil into a container.
NOTICE
Take care of filters, oils and liquids in an
environmentally safe way.
- Disconnect the drain hose and install the
protecting cap.
300
Maintenance
Maintenance service, every 50 hours
To Next Page
Loading...
