Swing gear bearing, greasing
Grease the swing gear every 250 hours.
1 Park the machine on level ground.
2 Lower the bucket to the ground.
3 Move the control lockout lever down to lock the
hydraulic system securely and stop the engine.
See page
111
.
4 Fill the grease in the grease nipples (A) using a
hand or power grease gun.
5 Apply grease to the swing bearing until grease
can be seen from the swing bearing seals.
6 Take care not to supply excessive mount of
grease.
7 After greasing, clean off the superfluous grease
completely.
308
Maintenance
Maintenance service, every 250 hours
To Next Page
Loading...
