Working within dangerous areas
Observe great care at marked danger areas.
Do not operate too close to the edge of a quay,
ramp, ditch and so on.
Move slowly when working in confined spaces
and check that there is sufficient room for
machine and load.
When working under ground, special equipment,
for example certified engine is required within the
EU and in EES countries. Talk to your dealer.
When working in low light conditions, for example
buildings and tunnels, use head light.
Do not operate the machine when visibility is poor
such as a heavy fog, snow or rain.
When working in an area which is contaminated
or dangerous to one's health, the machine must
be especially equipped for this purpose. Talk to
your dealer. Check also local regulations before
entering the area.
High voltage overhead power line
DANGER
Risk of electrocution
Working near or making contact with overhead
power lines may lead to electrical flashover and
electrocution.
Always keep the minimum clearance from
overhead power lines.
DANGER
Risk of electrocution.
Contact with live parts will cause death or serious
injury.
Never touch live electrical parts.
Operating techniques
Working within dangerous areas
213
To Next Page
Loading...
