Filling with auto shut-off controller (optional
equipment)
Fuel filler pump is installed in the tool box. Use it
when filling fuel in the tank.
NOTE!
This pump is provided with an electronic overfilling
protection.
1 Carefully clean around the fuel filler cap on the
fuel tank before removing it.
2 Open the fuel filler cap on the fuel tank.
3 Remove the strainer cover (E) which is installed
to protect the strainer from dust at the end of
hose (A).
4 Put the pump hose with strainer into the fuel
barrel.
5 Press the green start button (B). The pump will
run as long as the tank is not full.
- At any time during the refuelling or when the
drum has been emptied, the pump may be
stopped by pressing the red button (C).
- The pump will automatically stop when the fuel
level sensor is actuated. The pump cannot be
restarted until the fuel from the tank is used.
6 Fold the hose and reinstall the strainer cover.
NOTICE
Never allow the fuel filling pump to run dry. The
pump may be damaged.
A Fuel filler pump hose
B Start button (green)
C Stop button (red)
D Manual control button
E Strainer cover
324
Maintenance
Maintenance service, when required
To Next Page
Loading...
