Volvo EC140E - Specifications; Recommended lubricants

Specifications
Recommended lubricants
Recommended lubricants
The Volvo lubricants have been specially developed to fulfil the demanding operating
conditions, in which Volvo excavators are used in. The oils have been tested according
to Volvo excavator specifications and therefore meet the high requirements for safety and
quality. Other mineral oils can be used if they conform to our viscosity recommendations
and meet our quality requirements. The approval of Volvo is required, if any other oil base
quality (for example biologically degradable oil) is to be used.
System Oil grade Recommended viscosity at varying ambient
temperature
Engine Engine oil
For detail, see page
354 .
°C
°F
-30
-22
-10
-14
0
+32
+10
+50
+20
+68
+30
+86
+40
+104
+50
+122
-20
-4
SAE 10W-30***
*SAE 15W-40
SAE 10W-40
SAE 5W-30***
SAE 5W-40
Fuel Diesel fuel
For detail, see page
358 .
°C
°F
-30
-22
-10
-14
0
+32
+10
+50
+20
+68
+30
+86
+40
+104
+50
+122
-20
-4
*ASTM D975 No.2
ASTM D975 No.1
NOTE!
The fuel should at least meet the legal
requirement, and national and international
standards for marketed fuels, for example :
EN590 (with nationally adapted temperature
requirements), ASTM D975 No 1-D and No 2-
D, JIS KK 2204.
Cooling
system
Volvo Coolant VCS
Ready Mixed
For detail, see page
355 .
Volvo Coolant VCS Ready Mixed should be
used only.
NOTE!
The content of Volvo coolant must not be less
than 40% of the total mixture.
*: Installed at factory
***: VDS-4 or VDS-4.5 approved oils only. Other oils can be used up to +30°C (86°F).
Specifications
Recommended lubricants 351