Accumulator, pressure releasing
1 Lower the attachment or load completely to the
ground.
2 If using X1 or X3 axillary hydraulic circuit, do not
activate.
3 After turning off the engine, turn the ignition
switch to operating position.
4 Move the control lockout lever up to unlock the
system.
5 To release the pressure in the control circuits
and accumulator, move the operating levers and
pedals forward / rearward and left / right to their
respective end positions.
6 Turn the ignition switch to stop position.
7 Move the control lockout lever down to lock the
system securely.
Maintenance
Maintenance service, when required
347
To Next Page
Loading...
