Anti-vandal kit (optional equipment)
NOTE!
Clean mud, grease, oil, and debris from track
surface, steps, walkways, and working platforms
before installing the anti-vandalism covers.
Anti-vandal covers are stored on the cab.
The wing nut (A) should be tightened and the pin
(B) should also be in right position not to be loosen
when operating the machine.
Six brackets are needed to install the covers.
- To install the rear bracket (1), remove the rear
handrail (2) and reinstall it with rear bracket.
- Install two front brackets (4). For right side of front
bracket, remove the front handrail (3) and reinstall
it with front bracket.
- Install two lower brackets (5).
- Install the side bracket (6).
Tightening torque:
(1): 24 ± 2.4 Nm / 2.5 ± 0.3 kgf m / 17.8 ± 1.8 lbf ft
(2): 85 ± 8.8 Nm / 8.7 ± 0.9 kgf m / 62.9 ± 6.5 lbf ft
(3),(4),(5): 48 ± 4.9 Nm / 4.9 ± 0.5 kgf m / 35.5 ± 3.6
lbf ft
(6): 10 ± 1.0 Nm / 1.0 ± 0.1 kgf m / 7.4 ± 0.7 lbf ft
NOTE!
When storing the covers (C), make sure that the
locking screws do not cause interference between
covers.
A Wing nut
B Pin
C Covers
1 Rear bracket
2 Rear handrail
3 Front handrail
4 Front brackets
5 Lower brackets
6 Side bracket
110
Other controls
Cab
To Next Page
Loading...
