Cab prefilter, cleaning and replacing
If the cab prefilter is clogged, the fresh air flow rate
will be reduced. Therefore, clean it periodically.
Clean the cab prefilter every 250 hours and replace
it every 2000 hours.
WARNING
Risk of hazardous inhalation.
Dangerous dust can lead to serious health
problems.
Always wear personal protective equipment,
including filter mask, eye protection and appropriate
gloves when handling and cleaning the engine
compartment, coolers and air filters.
1 Turn the screw to counter clockwise using a L
wrench.
2 Tilt the cover (B) towards rear side and take out
the prefilter (A).
3 Clean the prefilter with compressed air.
NOTE!
When using compressed air, keep the nozzle at a
distance from the filter to prevent damage. Clean
the filter with compressed air with a maximum
pressure of 0.2 MPa (2 kgf cm
2
) (29 psi).
4 If the prefilter is damaged or heavily
contaminated, replace it with a new one.
5 Install the prefilter and close the cover.
A Cab prefilter
B Cover
C Screw
Maintenance
Maintenance service, every 250 hours
309
To Next Page
Loading...
