Track drive unit, checking oil level
Check the oil level every 1000 hours.
1 Turn the case so that drain plug is located at the
bottom.
2 Remove the level checking plug. If the oil is
about to overflow from the hole, the level is
correct.
If the oil is low, top up the oil to the correct level
through the filling plug. (If necessary, turn the case
so that filling plug is located at the top.)
For oil specification, see page
351
.
EC140E L
A Drain plug
B Level checking plug
C Filling plug
EC140E LM
A Drain and filling plug
B Level checking plug
316
Maintenance
Maintenance service, every 1000 hours