AdBlue®/DEF tank, draining
1 Park the machine on a level ground and move
the superstructure as shown in the figure.
2 Lower the bucket to the ground.
3 Turn the ignition switch to stop position.
4 Move the control lockout lever down to lock the
system securely. See page
111
.
5 Remove drain plug (A) using a L wrench from the
tank.
6 Drain AdBlue®/DEF into a container.
NOTICE
Take care of filters, oils and liquids in an
environmentally safe way.
7 Install the drain plug to the tank.
Water separator, draining
The water separator filter element is designed to
remove the water from the fuel supplied to the
engine.
Check and drain the water in the water separator
filter element when the check screen for water in
fuel pops up on the IC (Instrument Cluster).
1 Place a suitable sized container under drain
hose (E).
2 Open the drain valve (C) and drain the sediment
into a container.
NOTICE
Take care of filters, oils and liquids in an
environmentally safe way.
3 Close the drain valve (C).
A Drain plug
A Filter element
B Bowl
C Drain valve
D Sensor connector
E Drain hose
Maintenance
Maintenance service, when required
327
To Next Page
Loading...
