2 General information on programming the preset
time
Timer can be used to program 3 preset times.
The 3 preset times can either all take place on
one weekday or can be distributed between
different weekdays. 3 weekday ranges are
available to choose from, these can each be
started daily with a preset time.
Weekday ranges:
Day: Once
Sat-Sun: 2x Heating
Mon-Fri: 5x Heating
Mon-Sun: 7x Heating
- If the system is activated with programmed
weekday range, all weekdays are worked
through consecutively; after that renewed
programming is required.
- If the timer with a programmed weekday range
Mon – Fri is activated on Wednesday, the
heater heats on Thursday and Friday, the
heater is not operated on Saturday and
Sunday. From Monday to Wednesday of the
following week the operation is continued with
the set defaults (5x heating). After a weekday
range has been worked through renewed
programming is required.
Departure time operating mode (factory setting)
Under the following conditions the preselected
heating mode is not started on the current day.
The current day and the preselected day are
identical.
The current time lies within the time period,
departure time minus operating time.
A Preset unit
B Preset day
C Departure time
D Operating time
Other controls
Operator comfort
143
To Next Page
Loading...
