Operation and settings
Activating the timer
If the display is not lit, the timer has to be activated.
Pressing the operating button or BACK button
displays the Start mask.
Display
The display is lit:
- During operation of the timer
- When the heater is ON (the display goes out after
approx. 30 seconds).
Display goes out:
- No settings are made.
- No heater is switched on.
The timer then goes to sleep mode. Before going to
sleep mode, an overview mask is displayed. The
timer has to be activated (see above) before a new
input can be made.
Activating a function
The symbol of the function to be activated appears
in the middle and flashes in the display.
Flashing function / flashing value
- Select the flashing function in the menu bar by
pressing the operating button.
- Increase or decrease the flashing value by turning
the operating button. Then confirm the selected
value by pressing the operating button.
Cancel settings
Any settings being made can be cancelled with the
BACK button
.
NOTE!
Settings and changes must always be confirmed by
pressing the operating button, otherwise they will be
lost.
Setting the operating time
The operating time can be set individually using the
operating button.
- Turning to the right increases the operating time.
- Turning to the left decreases the operating time.
- Setting range for the operating time:
minimum 10 minutes to maximum 120 minutes in
one minute steps.
150
Other controls
Operator comfort
To Next Page
Loading...
