Waters 717plus - Page 103

Running Autosampling 103
4
4.6.4.2 Programming and Running Auto Addition
Before Programming
Before programming:
• Place your samples in the carousel, noting each position (usually in sequential order)
• Place your common vials in the carousel, noting each position (usually in sequential
order)
• Program the step on the Auto Run screen (Section 4.6.1,
Programming Auto Run)
• Program the step functions for the step (Section 4.6.2,
Programming Step Functions)
Programming Auto Addition
To program the Auto Addition routine:
1. From the Edit: Auto Run screen (Figure 4-10
), select a step, then press Step
Function to display the Edit: Step Function screen.
Note: For instructions on setting Needle Position and Purge, see Section 4.6.2,
Programming Step Functions.
2. From the Edit: Step Function screen (Figure 4-11
), press the down-arrow key to
move the cursor to the Option? field.
3. Press the right-arrow key to move the cursor to the Addn field. The Addn Page key
appears on the screen.
4. Press Addn Page to display the Auto Addition screen (Figure 4-15
).