Waters 717plus - Entering Hardware Changes; Setting IEEE-488 Address

Startup and Configuration 72
3
Figure 3-11 Setting IEEE-488 Address
3.6.3 Entering Hardware Changes
To enable the autosampler to adjust to changes in hardware configuration (syringe and
sample loop size), you must enter the changes on Configuration Page 3 (Figure 3-12
).
IDLE
Edit: Configuration Page 4 of 4
IEEE Address Assignment
PrevCfg
Page
Yes
Yes
30
Yes
20
NextCfg
Page
Main
Page
REBOOT
SYSTEM
Installed IEEE Address:
Desired IEEE Address:
Press REBOOT SYSTEM softkey to
install desired IEEE address.