Waters 717plus - Setting Terminal Strip Signal Parameters

Configuring the Autosampler 69
3
Figure 3-9 Setting the Integrator Report Delay
Setting Terminal Strip Signal Parameters
To set the contact closure parameters for LC components connected through the terminal
strip on the rear panel:
1. From the Main Menu, press Config Page.
2. Press NextCfg Page to access Configuration Page 2 (Figure 3-10
).
IDLE
Edit: Configuration Page 1 of 4
Use Door Sensor?
Purge In Idle?
Vials Between Purges :
Halt Bad Comp Check?
Report Delay (min) :
PrevCfg
Page
Yes
Yes
0
Yes
3.0
No
No
30
No
20
NextCfg
Page
Main
Page