Waters 717plus - Edit: Auto Standards Screen

Running Autosampling 99
4
• Place your standards in the carousel, noting each position (usually in sequential
order)
• Program the step on the Auto Run screen (see Section 4.6.1,
Programming Auto
Run)
• Program the step functions for the step (see Section 4.6.2,
Programming Step
Functions)
Programming Auto Standards
To program Auto Standards:
1. From the Edit: Auto Run screen (see Figure 4-10
), select a step, then press Step
Function to display the Edit: Step Function screen.
Note: For instructions on setting Needle Position and Purge, see Section 4.6.2,
Programming Step Functions.
2. From the Edit: Step Function screen (Figure 4-11
), press the down-arrow key to
move the cursor to the Option? field.
3. Press the right-arrow key to move the cursor to the Stds selection. The Stds Page
key appears on the screen.
4. Press Stds Page to display the Edit: Auto Standards screen (Figure 4-12
).
Figure 4-12 Edit: Auto Standards Screen
IDLE
Edit: Auto Standards 1 of 1 Stds
Editing Step:
Run Standards? Yes No
Vials Between 1
Vial
1
Inj
Vol
15.0
Step
Function
Delete
Table
Delete
Line
#
Inj
1
Run
Time
1.0