Waters 717plus - 4.6 Running Autosampling

Running Autosampling 91
4
• If the compression limit is exceeded, the following message appears:
Compressibility check failed
• If the compression check fails, review Section 4.1,
Overview of Operation, for further
testing.
4.6 Running Autosampling
This section describes:
• Programming an auto run
• Programming step functions
• Using Auto Standards
• Using Auto Addition
• Using Auto Transfer
• Programming the Event Output
• Starting and stopping an auto run
• Monitoring auto run status
Features of Auto Run
Use Auto Run mode to program, run, and monitor sample injections. Auto Run mode
allows:
• Multi-method programming – Allows programming of up to 96 different steps
(methods). Each step can use different numbers of injections, volumes, run times,
and optional functions.
• Unattended operation – Provides injection start and stop output signals for
controlling external devices.
• Programmable output signal – Allows the 717plus Autosampler to control external
devices during a run.
• Auto Standard, Auto Addition, and Auto Transfer functions – Allow automated
operation for standards, pre-injection addition of samples, and automatic pre-injection
transfer and mixing.