Waters 717plus - 4.6.7 Starting and Stopping an Auto Run

Running Autosampling 115
4
Starting
To start a run, press Start Auto, and the Auto Run Status screen appears.
Stopping
To stop an Auto Run:
1. Press Stop Run. A prompt appears:
Do you really want to stop the auto run?
2. Press Yes to stop the run.
If the autosampler is in the pre-injection sequence (sample is still in the sample
loop), you may either:
• Purge Sample – Flushes the sample to waste, and returns to the Edit Purge
menu. Select Main Page to return to the Main Menu.
• Inject Sample – Completes the injection sequence, and displays the Auto Run
Status screen. On the Auto Run Status screen, press Go to Idle to proceed with
programming. The Auto Page and Stat Run function keys allow you to view
parameters without making any changes.
4.6.8 Monitoring Auto Run Status
Monitor an auto run using the Auto Run Status screen (Figure 4-22).
Figure 4-22 Auto Run Status Screen
AUTO 28
i
Status: Auto Run
Vial #
Inj
Volume ( 1)
Runtime (min)
Time Remaining (min)
Total Runtime (min)
Stop
Run
Auto
Page
1
1
10.0
12.0
8.6
20.6
Stat
Run
Step 1 Vial1
1
of 2
10.0
12.0
8.6
20.6