Chapter 4 Tools
Configuration
WCDMA Options Version 6.20
115
AM Modulation — When a tick is shown in front of this list entry, the AM Signal
Generator Option is installed.
EDGE — When a tick is shown in front of this list entry, the EDGE System Option
software is installed.
OCXO — When a tick is shown in front of this list entry, the OCXO Option is
installed to provide a high-precision time base.
FEX — When a tick is shown in front of this list entry, the Frequency range
Extension Option is installed.
Turbo — When a tick is shown in front of this list entry, the Turbo Option is
installed.
TCP/IP — When a tick is shown in front of this list entry, the TCP/IP Option is
installed.
WCDMA Non-Call — When a tick is shown in front of this list entry, the
WCDMA Non-Call Mode Option is installed.
WCDMA Call Mode — When a tick is shown in front of this list entry, the
WCDMA Call Mode Option is installed.
TD-SCDMA Non-Call — When a tick is shown in front of this list entry, the
TD-SCDMA Non-Call Mode Option is installed.
Parallell Multiphone Test — When a tick is shown in front of this list entry, the
Parallel Multiphone Test Option is installed.
Installing additional options Some of the options of the 4400 require both software and hardware (like e.g.
the high-precision time base option or OCXO). These options can only be installed
by the Willtek product specialists.
Options that are software-based only (like ACPM for instance) may be installed
on-site. The only thing required then is a special code available from Willtek.
When you have the code at hands, follow the instructions below:
1 Push this softkey.
2 The
Input Option Key prompt will appear on the screen.
3 Enter the option key received from Willtek.
4 Confirm the option key entered by pushing the E
NTER function key or the
corresponding key on the external keyboard.
5 If the code is recognized by the 4400, it will display an ACCEPT message.
After leaving the entry box with the ESCape key, the tick in front of the
corresponding option will appear and the full functionality of the option will
be at your disposal.
6 In case the option key entered was not recognized by the 4400, you will see
the
NO VALID KEY! message. Try to enter the correct option key again.
To Next Page
Loading...
