Appendix A SCPI Command Reference
CONFigure subsystem
WCDMA Options Version 6.20
297
CONFigure subsystem
This subsystem incorporates all changeable NB parameters of all systems imple-
mented. The key commands are the following:
:CONFigure:CSYStem
CONFigure:CSYStem
Selects the communications system
to work with.
CONFigure:<SystemOption>:...
These commands select parameters
within a communications system.
CONFigure:<SystemOption>
:NB:...
These are the commands to set spe-
cific system parameters like the node
B’s RF output power level or its iden-
tity.
CONFigure:<SystemOption>
:UE:...
The mobile-specific information is
handed over to the 4400 using these
commands. One example is the power
level.
CONFigure:<SystemOption>
:BER:...
These commands set the BER parame-
ters.
CONFigure:<SystemOption>
:GROup:...
With the help of these commands,
groups of measurements may be
defined.
CONFigure:COUPloss:...
These commands provide access to
the coupling loss compensation fea-
ture of the 4400.
NOTE
Always select the communication system via the :Configure:CSYStem
command first before you change any parameters using different SCPI com-
mands.
Syntax
:CONFigure:CSYStem <PredefExp>
Parameters
PredefExp is one of the following predefined expressions:
NONe|GCGenana|GPGenana|EGPGenana|CDGenana|WCGenana|
AMGenana|GSM|GPRS|EGPRs|CDMA|WCDMa|AMPS|TDSCdma.
Default is NONe
To Next Page
Loading...
