Appendix A SCPI Command Reference
STATus subsystem
WCDMA Options Version 6.20
275
STATus subsystem
The STATus subsystem offers commands to read out and deal with
– the general operation register group and its subordinate groups of registers
and
– the general questionable status register group and its subordinate groups of
registers.
:STATus:PRESet
:STATus:OPERation[:EVENt]?
NOTE
The commands to deal with the event status register group and the service
register are part of the “SCPI command errors”.
NOTE
For further details on the STATus subsystem, please refer to section “Under-
standing the STATus subsystem” on page 229.
Syntax
:STATus:PRESet
Parameters
There are no parameters.
Description
This command sets all user-definable settings of the status subsystem to their factory
default values. The default values for the single commands are explained below.
Query
There is no query form of this command available.
Example
:STATus:PRESet
Will reset all parameters of the status subsystem to their default values as listed
below.
Syntax
:STATus:OPERation[:EVENt]?
Parameters
There are no parameters.
Description
Reads out the current contents of the General Operation Event Register.
Note: Event-type registers are read-only and self-destructive. They will be cleared
after any query.
To Next Page
Loading...
