Appendix A SCPI Command Reference
FORMat subsystem
296 WCDMA Options Version 6.20
:FORMat:ADELimiter
:FORMat:RESolution
Parameters
PredefExp is one of the following predefined expressions: OFF|ON. Default is
OFF.
Description
Switches the transmission of the additional information (see explanation of the com-
mand above) either on or off.
ON means that the current contents of the corresponding register(s) will be added at
the beginning of every string returned by a FETCh command.
Query
There is no query form of this command available.
Example
:FORM:MRES:HEAD
This command will switch the transmission of the additional information off.
Syntax
:FORMat:ADELimiter <PredefExp>
Parameters
PredefExp is one of the following predefined expressions:
COMMa|COLOn|SEMIcolon. Default is COMMa.
Description
Selects the delimiter to be used to separate parameters on commands and single
measurement result values.
COMMa stands for commas (default),
COLOn sets the delimiter to be a colon (:), while
SEMIcolon will use and expect a semicolon (;) to be used.
Query
There is no query form of this command available.
Example
:FORM:ADEL
Defines the comma to be used as delimiter for both commands and measurement
results.
Syntax
:FORMat:RESolution <int1>
Parameters
int1 is an integer. The minimum value for <int1> is 0, the maximum is 20. The
default value is 6.
Description
Defines the number of digits after the decimal point to be used for floating point real
numbers.
Query
There is no query form of this command available.
Example
:FORM:RES 0
Defines that there will be no digits after the decimal point.
To Next Page
Loading...
