Chapter 6 RAPID!
Using RAPID!
140 WCDMA Options Version 6.20
Open — A push on this softkey opens the file currently highlighted in the
Browser area. It also adds it to the RAPID! Basic File list.
After a file has been opened, you may edit, run or debug the file.
Save All — Saves all currently open files.
If there have been no changes made to a file since it was saved last, the file will
remain unchanged.
Close — Closes the file currently selected on the RAPID! Basic File selection field
list and removes it from the list.
If there have been any changes made to that file since it was saved last, you will
be prompted to save the file.
Open Project — This softkey works similar to the
Open softkey. Unlike the Open
softkey, this softkey does not only open the file selected (highlighted) but also all
basic files chained to this one.
All files will be added to the RAPID! Basic File list.
Next file — Pushing this softkey will activate the RAPID! basic file selection field
and allow you to select one of the currently open RAPID! basic files.
New Dir — Creates a new subdirectory in the directory currently shown in the
File Name – Directory – Selection display field.
The 4400 will prompt you with an entry field to enter the name of the subdirec-
tory to be created. To enter the name, use the external keyboard or the typing
tabs.
Copy — A push on this softkey allows you to copy the currently selected
(= highlighted) file. Additional softkey labels will be displayed that allow the
following choices:
OK – Copies the currently selected file. The 4400 will prompt you with a
dialogue box that allows you to enter the destination file name (including
directory). To enter the file and directory name, use the external keyboard or
the typing tabs.
to IO – Copies the currently selected file to the floppy inserted in the 4400’s
floppy drive. The copy of the file will have the same name as the original file.
to RAPID – Copies the currently selected file to the 4400’s internal hard disk
drive. The test set will prompt you with a dialogue box that allows you to
enter the destination file name (including directory). To enter the file and
directory name, use the external keyboard or the typing tabs.
Cancel – Quits the copy function and takes you back to the second set of
softkeys.
NOTE
As this softkey gives access to those three entry fields, you may also use this
softkey if you want to e.g. set a new filter for the files to be displayed within
the browser area (see section File name – directory – selection area for
details).
To Next Page
Loading...
