Maintenance1132−2/A1
Winterthur Gas & Diesel Ltd.
14/ 14
14) After each installation of a new bearing shell, measure the crank deflection, refer to
3103−1.
15) Do a check of an oil supply to the main bearing.
7. Main Bearing − Lubrication
After an overhaul of the bearing shells, more lubricant can be added to prevent
damage to the surface of the bearing shells. Refer to the Operation Manual, 0750−1
Lubricating Oils.
1) To fill the bearing shell with the lubricant do the procedure that follows:
a) Remove the blank flange (6, Fig. 28).
b) Remove the screw plug (5).
c) Fill the bearing shell with the applicable lubricant.
2015
Main Bearing − Removal and Installation
To Next Page
Loading...
Need help?
General
