Maintenance
2138−1/A2
Winterthur Gas & Diesel Ltd.
5/ 5
7) Tighten the nuts (10) of the union.
8) Step a) to step c) is only necessary if the cylinder liner was installed.
a) Remove the protection from the eight pipes (5).
b) Connect the eight pipes (5).
c) Attach the two holders (3) to the eight pipes (5).
9) Bleed the oil pipes (9) (refer to 7218−1, paragraph 3.2).
10) If necessary, bleed the flex lube pump (2) (refer to 7218−1, paragraph 3.1).
11) Do a function check of the cylinder lubricating system (see 7218−1,
paragraph 1.2).
2015
Lubricating Quill
To Next Page
Loading...
Need help?
General
