Xerox Phaser 3600

5-26 Phaser 3600 Printer Service Manual
Print-Quality Troubleshooting
4 Check the Print Cartridge for correct
installation. Reseat the Print Cartridge.
Does the error still occur?
Go to step 5. Complete.
5 Check the Separator Pad Assembly.
Is there damage or debris on the
Separat
or Pad?
Remove the
debri
s or replace
the Separator
Pad Assembly
(page 7-20).
Go to step 6.
6 Check for a skewed tray.
Is the skewed paper fed from Tray 1
(MP
T
)?
reseat the paper
and go
to step 7.
Go to step 7.
7 Check the Tray 1 (MPT) Side Guides.
Reset the Paper Gui
des.
Does the error still occur?
Go to step 8. Complete.
8 Replace the Tray 1 (MPT) Feed Roller
(page 7-14).
Does the error still occur?
Go to step 9. Complete.
9 Check the Registration Assembly and
Tr
ansfer Roller for correct installation.
Reseat the Transfer Roller (page 7-43).
Does the error still occur?
Replace the
Regi
stration
assembly
(page 7-41),
then go to step
10.
Complete.
10 Check the skewed mode through the
Dup
l
ex Unit.
Is the skewed paper fed the from the
Dupl
ex?
Go to step 11. Go to step 12.
11 Check the Duplex Unit for correct
i
n
stallation. Reseat the Duplex Roller
(page 7-47).
Does the error still occur?
Go to step 12. Complete.
12 Check additional paper trays for
corr
ect i
nstallation. Reseat the trays.
Does the error still occur?
Go to step 13. Complete.
13 Replace the Tray 2 Feed Roller
(page 7-30).
Does the error still occur?
Replace the
Retard
Assem
bly
(page 7-19).
Complete.
Troubleshooting Procedure Table (continued)
St
ep
Action and Questions Yes No