Xerox Phaser 3600

Phaser 3600 Printer Service Manual 7-55
Service Parts Disassembly
Fuser Interlock Switch (PL 1.3.77)
Warning
Be sure you turn off the Printer and let the Fuser cool for 5 minutes
1. Remove the Left Cover (page 7-7).
2. Remove the Rear Cover (page 7-8).
3. Follow the instructions for removing the SMPS Power Supply (page 7-76).
4. Disconnect the connector from CON5 of the SMPS Power Supply.
5. From the bottom of the printer, remove the screws holding the sensor to
the chassis.
6. Remove the Fuser Interlock Switch and wire harness.
s3600-102