Xerox Phaser 3600

7-6 Phaser 3600 Printer Service Manual
Service Parts Disassembly
Covers and Control Panel
Right Cover (PL 1.2.3)
1. Turn OFF the Printer Power Switch and unplug the power cord.
2. Remove the Duplex Unit (page 7-37).
3. Remove the 2 rear screws securing the Right Cover to the rear of the
printer.
4. Remove the right side access cover.
5. To remove from the printer, slide the Right Cover towards the rear of the
printer to release the 3 tabs on the top of the cover and 3 hooks on the
bottom of the cover.
Replacement Note
When reinstalling the cover, insert the 3 bottom hooks first, then slide
the cover from the rear to the front. Make sure the cover is securely
behind the 3 tabs.
s3600-027