Xerox Phaser 3600

7-38 Phaser 3600 Printer Service Manual
Service Parts Disassembly
Main Drive and Registration Assemblies
Main Drive Assembly (PL 1.1.18)
Caution
When removing screw #3 in step 3, make sure you do not bend or break the
wire connected to the varistor. Also, screw #4 has a grounding strap that must
be replaced during reassembly.
1. Remove the Right Cover (page 7-6).
2. Disconnect the CN1 cable on the Main Drive assembly. The other end is
attached to the Main Board at CN19 DC Motor.
3. Remove all 6 screws in order. The screw numbers are labeled on the
main assembly plate.
4. Remove the Main Drive Assembly.
Caution
Be careful not to reposition the gears.
s3600-050
1
2
3
4
5
6