Xerox Phaser 6120

Disassembly/Assembly Procedures
Phaser® 6120 Color Laser Printer Service Manual
5-17
High Voltage Unit (HV)
Warning: Make sure the power switch is off and the cord is unplugged prior to starting this
(or any other) disassembly procedure.
1. Remove the Left Cover. See Left Cover on page 5-5.
2. Remove four screws [1].
3. Disconnect two connectors [2] and remove the High Voltage Unit [3].
Caution: Do not damage the springs. Use caution around the springs. Confirm that all
5 springs are securely in place and are not bent prior to reinstalling the HV Board
[1]
[1]
4139fs2027c0
[2]
[3]
4139fs2028c0