Xerox Phaser 6120

Disassembly/Assembly Procedures
Phaser® 6120 Color Laser Printer Service Manual
5-25
11. Remove five screws [4].
12. Remove the PJ22 connector from the PWB-A (Engine Control Board).
13. Remove one screw and the metal plate from the right side, rear of the printer.
14. Remove the black plastic guide by pushing the two locking tabs on the right side, and then
allow the guide to fall.
Note: Notice the orientation of the black plastic guide and reinstall it in the same
orientation.
15. Pull the tray completely towards you and remove the Paper Pick-up Unit [6].
Notes for Reassembly
1. Ensure that the cams on the take-up assembly are in the up position.
2. Insert the black and red solenoid harness through the opening on the left side of the
chassis.
[4]
[4]
4139fs2063c3
Printer
Top
Printer
Bottom
Printer
Bottom
Printer
Top
[6]
4139fs2064c3