Xerox Phaser 6120 Service Manual

Phaser® 6120 Color Laser Printer Service Manual
3-21
NETZONE
NETZONE 2
ETHERNET SPEED
PS PROTOCOL
USB SETUP
ENABLE
JOB TIMEOUT
Function Specifies the first part of the Macintosh EtherTalk zone name.
Use
■ To set the Zone name on Macintosh EtherTalk (AppleTalk) network where
the printer is located.
■ The zone name can contain a maximum of 16 characters.
Setting/procedure The default setting is ✱.
Function Specifies the second part of the Macintosh EtherTalk zone name.
Use
■ To set the Zone name connected with Macintosh EtherTalk (AppleTalk)
network where the printer is located.
■ The zone name can contain a maximum of 16 characters.
Setting/procedure The default setting is NULL.
Function Specifies the transmission speed for the network and the transmission
method for bi-directional transmission.
Use To set the specific network speed and the transmission method.
Setting/procedure The default setting is Auto.
“Auto”, 100 Full Duplex, 100 Half Duplex, 10 Full Duplex, 10 Half Duplex
Note: Make sure to turn the Power Switch OFF and ON again after changing
the network speed.
Function Selects whether PostScript jobs are received in the binary format or the
quoted format.
Use To transmit PostScript data in quoted format.
Setting/procedure The default setting is BINARY.
“BINARY”, QUOTED BINARY
Function Specifies whether to enable or disable USB.
Use To disable USB.
Setting/procedure The default setting is YES.
“YES”. NO
Function Specifies the length of time until the print job being received is timed out
when the USB interface is being used.
Use To set the amount of time before a print job sent to the USB interface times
out.
Setting/procedure The default setting is 60 (seconds).
0 to 999

Xerox Phaser 6120 Specifications

General

Color	Yes
Print technology	Laser
Time to first page (black, normal)	13 s
Time to first page (color, normal)	22 s
Print speed (black, normal quality, A4/US Letter)	20 ppm
Print speed (color, normal quality, A4/US Letter)	5 ppm
Internal memory	128 MB
Processor model	300 MHz, 32 bit RISC
Maximum print size	210 x 297 mm
Maximum ISO A-series paper size	A4
I/O ports	USB
Power requirements	200 – 240 VAC / 100 – 127 VAC 50/60 Hz
Networking features	Ethernet/Fast-Ethernet
Non-operating relative humidity (non-condensing)	10 - 85 %
Total input capacity	200 sheets
Maximum input capacity	500 sheets
Printer fonts	PostScript
Maximum duty cycle	35000 pages per month
Number of PostScript fonts	139
Power consumption (printing)	380 W
Storage temperature (T-T)	-20 - 40 °C
Operating temperature (T-T)	10 - 32 °C
Operating relative humidity (H-H)	10 - 80 %

Weight and Dimensions

Dimensions (WxDxH)	442 x 395 x 341 mm